4.1. ERMUSR 09-10-2019 - Laserfiche WebLink

Home Browse Search

may be used for water service pipe only up to the water meter. Particular care shall be taken to avoid sharp edges in contact with the pipe and provide for expansion and contraction. All service connections larger than 2" (two inches)are required to be pressure tested at 150 lbs. (one hundred fifty pounds) psi for 1(one) hour with no loss of pressure. AWWA approved Polyethylene(PE)—B72.1—D2239 material is required for water services. All fire protection lines shall have detector check valves. e) An angle meter valve is required for all 2" (two inch)and smaller services. Valves must be manufactured in compliance with: ANSI/AWWA C800, brass components conform to ASTM B62 & ASTM B584, UNS C83600-85-5-5-5, PTFE coated brass ball, rated for 300 PSIG water pressure, blow out proof EPDM port seals,End piece joint sealed with an EPDM o-ring and thread locker. f) Where pressure reducers are required,the pressure reducer(supplied by plumber)will be located on the house side of the meter and before the second valve and meters will be marked with pressure reducer notation. g) Connection, access, and meter fees must be paid and a copy of the plumbing permit supplied, before delivery of the water meter will be made. The current WAC fee per ERMU fee schedule, plus tax,will be paid at this time upon determination of total WAC units which is a function of building occupancy and is determined by the City Building Official. h) Plumber to install meter and call ERMU for meter to be sealed at least 24 hours in advance. i) The ERT will be installed by the water utility if necessary when the plumber has completed the setting of the water meter. Notification by the plumber that the water meter has been set and is ready for the ERT, shall be done at least 24 hours prior to final plumbing inspection by the City Building Inspection Department. No Certificate of Occupancy (C.O.) will be issued until the ERT has been installed by ERMU and the meter has been sealed. j) Any damage to the ERT after it has been installed by ERMU will be the responsibility of the builder or property owner. 148