8.1. SR 06-03-2019 - Laserfiche WebLink

Home Browse Search

W WASTE MANAGEMENT Construction Schedule updates and revisions shall indicate actual progress of the Work in the field and shall include Amendments, if any, impacting the progress of the Work. 3.14.4 No revision or update to the Construction Schedule shall relieve Contractor of its obligation to complete the Work within the Contract Time. 3.14.5 Contractor shall perform the Work in general conformance with the most recent Construction Schedule submitted to Owner. 3.15 Documents and Samples at the Site 3.15.1 Contractor shall maintain and make available to the Owner's Authorized Representative one record copy of Contract Documents, including Record Drawings. Such documents shall be maintained in good order and kept current to record Amendments, selections made during construction, minor changes in the Work and approved deviations from the Contract Documents, if any. 3.15.2 Contractor shall also maintain and make available to the Owner's Authorized Representative for review approved Shop Drawings, Product Data, Samples, and similar submittals. These shall be delivered to the Owner's Authorized Representative prior to final inspection as required in Article 9. 3.16 Manufacturer's Specifications 3.16.1 Contractor shall offload, store, handle and install all materials and perform all Work in the manner required by any applicable materials manufacturers whose Products are incorporated into the Work, including any Owner furnished materials. Should the Contract Documents and manufacturer's instructions conflict, Contractor shall report the conflict to the Owner's Authorized Representative for resolution prior to proceeding with the Work. 3.16.2 References to the manufacturer's specifications, manufacturer's directions, or manufacturer's recommendations, shall refer to the referenced manufacturer's current published documents in effect as of the date of receipt of bids, or for Change Orders, as of the date of the Change Order. 3.17 Shop Drawings, Product Data, and Samples 3.17.1 Shop Drawings, Product Data, and Samples are not Contract Documents. The purpose of their submittal is to demonstrate, for those portions of the Work for which submittals are required, the way Contractor proposes to conform to the information given and the design concept expressed in the Contract Documents. 3.17.2 Contractor shall submit to the Owner's Authorized Representative the Shop Drawings, Product Data, and Samples required by the Contract Documents in the forms, quantities, and procedures specified in the Specifications. Submittals shall be transmitted with reasonable promptness and in such sequence as to cause no delay in the Work or in the activities of Owner or of a Separate Contractor. Submittals made by Contractor which are not required by the Contract Documents or which are indicated to be for information only may be returned without action. If, in the opinion of the Owner's Authorized Representative, the submittals are incomplete, indicate an inadequate understanding of the Work covered by the submittal, or indicate a lack of review by Contractor prior to submittal, the submittal may be returned unchecked to Contractor for correction of deficiencies and subsequent resubmittal. 3.17.3 Contractor shall perform no portion of the Work requiring submittal and review of Shop Drawings, Product Data, and Samples until the respective submittal has been returned with appropriate action. Such Work shall be in accordance with reviewed submittals, unless the submittals are subsequently found to be defective. When Shop Drawings, Product Data, and Samples are required, related Work performed prior to review and approval of such submittals shall be at Contractor's risk, and Owner shall not be obligated to accept such Work if such submittals are later found to be not acceptable. 3.17.4 Contractor shall review and certify that all submitted Shop Drawings, Product Data, and Samples conform to Contract Documents without exception by affixing Contractor's approval stamp and 15 Jun-17 Ver.2.0