4.2. SR 04-23-2001 - Laserfiche WebLink

Home Browse Search

Bidder Triple Combination Pumper Specifications for thc 14 Complies Cit of Elk River Minnesota Yes No Construction of the cab shall consist of 5052-.125" aluminum welded to extruded aluminum framing. The cab shall be 96.00" wide, with an interior width of 87.50". From the centerline of the front axle to the back of the cab shall be a minimum of 67". The forward cab section overall height (cab roof to ground) shall be approximately 99.00". The crew cab section shall have a 10.00" raised roof with an overall cab height of 109". The floor to ceiling height inside the crew cab shall be 62.50. The crew cab floor shall measure 48.75" from rear wall to the "back" side of engine tunnel. The crew cab shall be of the totally enclosed design, with access doors constructed in the same manner as the driver and passenger doors. The cab shall be a full tilt cab style. The engine shall be easily accessible and capable of being removed wkh the cab tilted. Provisions for checking the transmission, oil, and power steering fluid levels shall be placed so that they are accessible without raising the cab. The cab shall have three (3)-point rubber mounting and shall be tilted by a hydraulic pump connected to two (2) cab lif~ cylinders. The cab shall then be locked down by a two (2)-point autOmatic locking mechanism that actuates after the cab has been lowered. The cab access steps shall be 22.00" wide, crew cab shall be 21.50" wide x 8.00" minimum depth, located inside the door, protecting the step from weather elements. The inside cab steps shall not exceed 16.50" high. The crew cab entrance shall be a two (2) step design for easy access. A 20.00", slip resistant, handrail shall be provided adjacent to all door openings to assist entrance into the cab. A rubber-covered handrail shall be provided inside each front cab door, adjacent to the door posts. The cab doors shall be 35.00" wide x 69.00" high. Page 14