6.6. SR 08-19-2002 - Laserfiche WebLink

Home Browse Search

DRAINAGE AET #20-02044 - Page 20 BASEMENT/RETAINING WALL BACKFILL AND WATER CONTROL Below grade basements should include a perimeter backfill drainage system on the exterior side of the wail. The exception may be where basements lie within free draining sands where water will not perch in the backfill. Drainage systems should consist of perforated or slotted PVC drainage pipes located at the bottom of the backfill trench, lower than the interior floor grade. The drain pipe should be surrounded by properly graded filter rock. A filter fabric should then envelope the filter rock. The drain pipe should be connected to a suitable means of disposai, such as a sump basket or a gravity outfall. A storm sewer gravity outfail would be preferred over exterior daylighting, as the latter may freeze during winter. For non-building, exterior retaining walls, weep holes at the base of the wail can be substituted for a drain pipe. BACKFILLING Prior to backfilling, damp/water proofing should be applied on perimeter basement walls. The backfill materiais placed against basement walls will exert laterai loadings. To reduce this loading by allowing for drainage, we recommend using free draining sands for backfill. The zone of sand backfill should extend outward from the wail at least 2', and then upward and outward from the wall at a 30° or greater angle from vertical. As a minimum, the sands should contain no greater than 12 % by weight passing the//200 sieve, which would include (SP) and (SP-SM) soils. The sand backfill should be placed in lifts and compacted with portable compaction equipment. This compaction should be to the specified levels if slabs or pavements are placed above. Where slab/pavements are not above, we recommend capping the sand backfill with a layer of clayey soil to minimize surface water infiltration. Positive surface drainage away from the building should also be maintained. If surface capping or positive surface drainage cannot be maintained, then the trench should be filled with more permeable soils, such as the Fine Filter or Coarse Filter Aggregates defined in MnDOT Specification 3149. You should recognize that if the backfill soils are not properly compacted, settlements may occur which may affect surface drainage away from the building. Backfilling with silty or clayey soil is possible but not preferred. These soils can build-up water which increases lateral pressures and results in wet wall conditions and possible water infiltration into the basement. If you elect to place silty or clayey soils as backfill, we recommend you place a prefabricated drainage composite against the wail which is hydraulically connected to a drainage pipe at the base of the backfill trench. High plasticity clays should be avoided as backfill due to their swelling potential. LATERAL PRESSURES _Laterai earth pressures on below grade walls vary, depending on backfill soil classification, backfill compaction and slope of the backfill surface. Static or dynamic surcharge loads near the wall will also increase lateral wall pressure. For design, we recOmmend the following ultimate laterai earth pressure values (given in equivalent fluid pressure vaiues) for a drained soil compacted to 95 % of the Standard Proctor density and a level ground surface. Soil Type Equivalent Fluid Density Active (pcf) At-Rest (pc0 Sands (SP or SP-SM) Silty Sands (SM) Fine Grained Soils (SC, CL or ML) 35 50 45 65 70 90 Basement walls are normally restrained at the top which restricts movement. In this case, the design laterai pressures should be the "at-rest" pressure situation. Retaining walls which are free to rotate or deflect should be designed using the active case. Lateral earth pressures will be significantly higher than that shown if the backfill soils are not drained and become saturated. 01REP014(7/01) AMERICAN ENGINEERING TESTING, INC.