91-023 ORD - Laserfiche WebLink

Home Browse Search

1,100 .116 .058 .029 . 1,200 .125 .064 .032 1,300 .133 .068 .034 1,400 .142 .072 .036 1,500 .150 .075 .038 * for average unit floor areas less than shown, use the floor area ratios listed for 200 square feet. For areas greater than shown, use the ratios listed for 1,500 square feet. For recreational camping areas, use the ratios listed at 400 square feet. Manufactured home sites in recreational camping areas shall use a ratio equal to the size of the manufactured home, or if unknown, the ratio listed for 1,000 square feet. iii. Multiply the useable area within each tier by the floor area ratio to yield total floor area for each tier allowed to be used for dwelling units or sites. iv. Divide the area computed in subitem iii. by the average determined in subitem i. This yields a base number of dwelling units and sites for each tier. . v. Determine whether the project is eligible for any additional density increases. To be eligible, projects shall meet all of the design standards in item b below and exceed one or more of them. The City may decide how much, if any, increase in density to allow for each tier, but shall not exceed the maximum allowable density increases listed in the following table: Maximum Allowable Dwelling Unit Or Site Density Increases for Commercial Planned Unit Developments Tier Maximum density increase within each tier (percent) First Second Third Fourth Fifth 50 100 200 200 200 vi. Allowable densities may be transferred from any tier to any other tier further from the shore land lake or river, but shall not be transferred to any other tier closer. . b. The design criteria are: 9.180