Laserfiche WebLink
<br />Page 14 <br /> <br />e <br /> <br />removing the special flood hazard area designation for <br />certain structures properly elevated on fill above the <br />100-year flood elevation - FEMA's requirements incorporate <br />specific fill compaction and side slope protection <br />standards for multi-structure or multi-lot developments. <br />These standards should be investigated prior to the <br />initiation of site preparation if a change of special <br />flood hazard area designation will be requested. <br /> <br />E. Floodplain developments shall not adversely affect <br />the hydraulic capacity of the channel and adjoining <br />floodplain of any tributary watercourse or drainage system <br />where a floodway or other encroachment limit has not been <br />specified on the Official Zoning Map. <br /> <br />F. Standards for travel trailers and travel vehicles are <br />contained in Section 902.20(3}. <br /> <br />e <br /> <br />G. All manufactured homes must be securely anchored to <br />an adequately anchored foundation system that resists <br />flotation, collapse and lateral movement. Methods of <br />anchoring may include, but are not to be limited to, use <br />of over-the-top or frame ties to ground anchors. This <br />requirement is in addition to applicable state or local <br />anchoring requirements for resisting wind forces. <br /> <br />902.10 - p'ubdivisions. <br /> <br />1. ~eview Criteria. No land shall be subdivided which is <br />unsuitable for the reason of flooding, inadequate drainage, <br />water supply or sewage treatment facilities. All lots within <br />the floodplain districts shall contain a building site at or <br />above the Regulatory Flood Protection Elevation. All <br />subdivisions shall have water and sewage treatment facilities <br />that comply with the provisions of this Ordinance and have road <br />access both to the subdivision and to the individual building <br />sites no lower than two (2} feet below the Regulatory Flood <br />Protection Elevation. For all subdivisions in the floodplain, <br />the Floodway and Flood Fringe boundaries, the Regulatory Flood <br />Protection Elevation and the required elevation of all access <br />roads shall be clearly labeled on all required subdivision <br />drawings and platting documents. <br /> <br />- <br /> <br />2. .Eemoval of Special Flood Hazard Area Desiqnation. The <br />Federal Emergency Management Agency (FEMA} has established <br />criteria for removing the special flood hazard area designation <br />for certain structures properly elevated on fill above the <br />100-year flood elevation. FEMA's requirements incorporate <br />specific fill compaction and side slope protection standards <br />for multi-structure or multi-lot developments. These standards <br />should be investigated prior to the initiation of site <br />preparation if a change of special flood hazard area <br />designation will be requested. <br />