Laserfiche WebLink
<br />OPTION B <br /> <br />E. ~sory structures not exr.pplli"g one hundred twenty (120) square feet in floor area may <br />be pennitted in any ?X>ne and may be :finished with metal panel sidin~ wood, vinyl lap. siding, metal <br />lap siding. and! or masonry so long as the structures complywith the required mininnlOl setbacks and <br />~ structures are anchored to the ground in compliance with aU applicable building codes. <br /> <br />F. On lotS less than two and one half (2 1/2) acres in the Rib, Rlc, Rld or Rle districts, no <br />detached accessory structures greater than one hundred twenty (120) square feet shall be finished <br />with metal panel sidin&_ In the Ai and Ria districts, and on two and ~ half (2 1/2) acres or greater <br />in theRlb, Rlc, Rld or Rle districts, accessory structures may be fini!:hetl with metal panel sidint. <br />wood, vinyl lap siding, metal lap siding. and! or masonry.. Metal panel siding shall be allowed as a <br />roofing material on any accessory structure. <br /> <br />G. In .QnyZDne, aU metal finishesl coverings shall be factory pre-finished. IIi all zones, except <br />Ai, galvanized corrogated panels shall not be allowed. All accessory structures greater than one <br />hundred twenty (120) square feet: shall require a building pennit and complywitb.all applicable <br />buiIdin,g codes. . .. . <br /> <br /> <br /> <br /> <br /> <br /> <br />Definitions: <br /> <br />Metal Panel Siding: Metal finishesl coverings that are applied to the exterior of walls and roofs which <br />are greater than eight (8) inches in width. . <br /> <br />Metal Lap Silling: Metal fini~hesl coverings that are applied to the exterior of walls and roofs which <br />are eight (8) inches or less in width. <br /> <br />