Laserfiche WebLink
SP0178-2007 <br /> NACE International gratefully acknowledges the contributions of the following companies in the <br /> preparation of the welding samples and the fabrication of the die from which the plastic replicas <br /> have been molded: <br /> Ausimont USA, Inc.,t21 Thorofare, NJ <br /> CenterPoint Energy,t31 Houston TX <br /> S.G. Pinney&Associates, Inc.,(4)Port St. Lucie, FL <br /> The Sherwin-Williams Company,151 Cleveland, OH <br /> NACE also gratefully acknowledges the assistance of KTA-Tator Inc.,tsl Pittsburgh, PA, in <br /> developing the weld pattern that was used to mold the plastic replica of weld samples. <br /> In NACE standards, the terms shall, must, should, and may are used in accordance with the <br /> definitions of these terms in the NACE Publications Style Manual, 4th ed., Paragraph 7.4.1.9. Shall <br /> and must are used to state mandatory requirements. Should is used to state something considered <br /> good and is recommended but is not mandatory. May is used to state something considered <br /> optional. <br /> (2)Ausimont USA, Inc., 10 Leonards Lane,Thorofare,NJ 08086. <br /> (3)CenterPoint Energy,P.O.Box 1325,Houston,TX 77251-1325. <br /> (4)S.G.Pinney&Associates, Inc.,Corporate Office, 1326 S.W. Biltmore St., Port St.Lucie,FL 34983. <br /> (5)The Sherwin-Williams Company, 101 Prospect Avenue N.W.,Cleveland,OH 44115. <br /> 161 KTA-Tator, Inc., 115 Technology Drive, Pittsburgh, PA 15275. <br /> it NACE International <br /> 181 <br />